The accessories that are intended for the datam model VNS6 are designed to be used in the most convenient way possible. In the package that we offer, we have considered a base and an arm, which type of connection is very simple.
The base of the vein detector consists of two main arms that can be adjusted in different angles. The first setting is from the black base part, which can be installed in the desired location in two ways, which we will explain below.

The next arm is also adjustable from the middle part. These arms are connected through Allen screws to provide maximum safety. To adjust the arms, either from the beginning of the connection to the table with the chair or in the middle of the two arms, first loosen the screws with the wrench that is in the packaging of the device, and then tighten them at the right angle with the same wrench.

The second adjustment section is at the end of the two arms, which can adjust the device in the Z axis. In that section, the same type of screw with the same size is used. This part is connected to the end of the arm on one side and to the device itself on the other side.
As described in the previous method, we first loosen it with a wrench, adjust the angle and finally tighten the screw. This part is connected to the end of the arm on one side and to the device itself on the other side.

Of course, the complete and comprehensive installation method is included in the manual of the device with a visual guide. Another thing we are referring to is the end part of the device. This part is designed so that it can be connected to the desired place with 4 automatic screws (which are also included in the mobile devices) or connected with a big L screw. Of course, in the second method of adjustment, the base can be connected to places that have edges. Like the edge of a table or chair.
Always pay attention to install the base first and then connect the device to it. We mention this in order to prevent the device from falling.
Among the parts in the accompanying package:

• The main device
• the arms
• A number of garou for special cases
• Automatic screws
• allen wrench
• 6-sided tightening screw in the temporary connection mode of the base
• Device pencil to change settings manually
• Manual

are In any case, don’t worry about the base package and connections because all the explanations in the manual are provided in the order of the picture and we have mentioned it in general in this section.